Submission Details

avatar

- Extreme League

1min 3sec 31ms with Intel Pentium III-S 1266Mhz at 1978MHz

Ranking position

n/a

Global rank:

3rd

Pentium III-S 1266Mhz rank:

Cup Bronze 3rd out of 32

Points earned for overclocker league

Points earned for team league

Media gallery

Screenshots
SuperPi - 1M screenshot

Hardware details

CPU details

Memory details

  • Manufacturer: Infineon
  • Cooling: Single Stage Phase Change
  • Temperature (°C): -50 (load)-60 (idle)15 (ambient)
  • Type: 512MB SDR SDRAM
  • Timings: 2-2-2-7-9

VGA details

  • Speed: MHz / MHz (Stock)

Mainboard details

Disk details

Power details

Recent Comments

ItalyGigioracing says:

need ln2 cpu and ram for broken the minute

ItalyStermy57 says:

Secondo con qualche tweaks limi

 

ItalyGigioracing says:

Secondo con qualche tweaks limi

 

quando passi da queste parti ? :-)

ItalyStermy57 says:

Dobbiamo incontrarci il prima possibile magari durante un fine settimana! Più siamo meglio è :)

dobbiamo organizzarci

Russian FederationTerraRaptor says:

nice result, but why no tweaks?

ItalyGigioracing says:

nice result, but why no tweaks?

 

I have used tweak but cpu freq is too low For broken the minute. Needed a,good p3 1.4s

ItalyStermy57 says:

Terraraptor in fact i wrote: " in My opinion you can improve it " but is only a supposition maybe he needs another p3

Russian FederationTerraRaptor says:

nope. With proper waza this will brake 1.02 for sure and probably 1.01. My estimations are that I need 1.4S @200fsb to break 1m. This setup is really close to my estimation in terms of performance. Proper waza + well tweaked os + known tweaks to superpi + tweaks to i815 are way to go below 1m with this setup. I had 1.03.5xx @194.5mhz with 1.4S. Almost 10% difference in ram should be more than 500ms and 70 mhz in cpu.

ItalyStermy57 says:

Mee to, i think the same ;)

for me is impossible...my best sdram runs at 165 CAS 2-2-2-5-7 and only 195Mhz CAS 3

Italyruggero says:

nope. With proper waza this will brake 1.02 for sure and probably 1.01. My estimations are that I need 1.4S @200fsb to break 1m. This setup is really close to my estimation in terms of performance. Proper waza + well tweaked os + known tweaks to superpi + tweaks to i815 are way to go below 1m with this setup. I had 1.03.5xx @194.5mhz with 1.4S. Almost 10% difference in ram should be more than 500ms and 70 mhz in cpu.

 

Uhm,in my opinion 200*10,5 1:1 2 2 2 7 9 is not sufficient to break 1m.

Russian FederationGraduS says:

200*10,5 1:1 2 2 2 7 9 = 100% sub1m

Italyruggero says:

200*10,5 1:1 2 2 2 7 9 = 100% sub1m

 

188.55 1.05.374 tera

 

191.31 1.03.982 grad + 2,76 mhz -1,392s -0,5s for +1 mhz

 

194.5 1.02.940 tera + 3,19 mhz -1,042s -0.3s for + 1 mhz

 

200 xxxxxx + 5.5 mhz...-2.5s...1.00.4xx

 

Now there are two score at 200*10,5 2 2 2 7 9

 

1) 1.05.514 by gradus

2) 1.02.379 by me...my score is just for fun,I wanted bench seriously but I sold everything :-(

 

But in my opinion for gradus is better 4/3 around 240/185 2 2 2 5 7 :D

Russian FederationGraduS says:

1) 1.05.514 by gradus - shit old result on wrong win.

 

240/180, not 185. but i think 230+ 2-3-3 mem better for 1m.

Russian FederationGraduS says:

RUGGERO what mem you use when 200 2-2-2-7-9?

Italyruggero says:

1) 1.05.514 by gradus - bunnyextraction old result on wrong win.

 

240/180, not 185. but i think 230+ 2-3-3 mem better for 1m.

 

Wr frequency of sdram is 3 3 3 7 9 and you close a superpi 1m a 230 mhz 2 3 3 xx?It's a incredible ram,the bh-5 of sdram.

 

I sold that ram,but if you want I can try to find the model,I writed down this in a book,but I don't remember where is the book :D

Russian FederationGraduS says:

NO! i dont have that ram, but ez! at the moment only 213 2-3-3 -20C 1m and 215+ valid. ez 220+ on LN2. but this module very bunnyextractionty, pos find better.

 

btw 230 3-3-3 so bad result.....

 

PS "bunnyextractionty" lol....wtf correction? :D

Italyruggero says:

NO! i dont have that ram, but ez! at the moment only 213 2-3-3 -20C 1m and 215+ valid. ez 220+ on LN2. but this module very bunnyextractionty, pos find better.

 

btw 230 3-3-3 so bad result.....

 

PS "bunnyextractionty" lol....wtf correction? :D

 

Ehm...sorry but my english is not very good,if you use slang for me is impossible understand.

 

"that ram, but ez"...what's ez?what's "bunnyextractionty"?

ItalySkyline says:

Ehm...sorry but my english is not very good,if you use slang for me is impossible understand.

 

"that ram, but ez"...what's ez?what's "bunnyextractionty"?

 

I'm pretty sure that "EZ" is short for easy as "not a problem".

 

The Hwbot forum filter swear words and change them in "bunnyextraction" or similar forms. :)

 

By the way you are rug22 isn't it?

Italyruggero says:

I'm pretty sure that "EZ" is short for easy as "not a problem".

 

The Hwbot forum filter swear words and change them in "bunnyextraction" or similar forms. :)

 

By the way you are rug22 isn't it?

 

 

Yes,rug22...ok,thank's for the explanation.

 

 

NO! i dont have that ram, but ez! at the moment only 213 2-3-3 -20C 1m and 215+ valid. ez 220+ on LN2. but this module very bunnyextractionty, pos find better.

 

btw 230 3-3-3 so bad result.....

 

PS "bunnyextractionty" lol....wtf correction? :D

 

I find the book,ram was kingmax pc 150

 

1)170/175 2 2 2 7 9 on air 3,90 volt 1m

2)190/195 2 2 2 7 9 with cpu on ln2 and ram on "air"* 3,90 volt 1m

3)200/202 2 2 2 7 9 with cpu and ram ln2 3,90 volt 1m around -80°

 

*The cpu pot cools also the ram,I think ram as around -30°.

 

My ram were similar to those of gigio,3 MHz in less may be,but gigio use vdimm over 4 volt.

 

In my opinion sdram capable of 200 2 2 2 7 9 on air don't exist,as sdram capable of 230 2 3 3 1m ready,i have tested more or less 30 different chips.

 

I hope I was helpful ;-)

Russian FederationGraduS says:

i have kingmax pc150. all same results with it.

170+ 2-2-2-7-9 3.8v air

200 2-2-2-7-9 3.8v -70C

 

 

"In my opinion sdram capable of 200 2 2 2 7 9 on air don't exis"

how gigiracing bench on 210 22279 then? he told that 210 on air.

 

I test 200+modules of sdram this month....

Italyruggero says:

i have kingmax pc150. all same results with it.

170+ 2-2-2-7-9 3.8v air

200 2-2-2-7-9 3.8v -70C

 

 

"In my opinion sdram capable of 200 2 2 2 7 9 on air don't exis"

how gigiracing bench on 210 22279 then? he told that 210 on air.

 

I test 200+modules of sdram this month....

 

ah,I understand your doubt :D

 

My ram with normal air was around 170/175 mhz 2 2 2 7 9,first time with cpu ln2 ram close superpi around 190.

 

Why?Because the smoke which exits from the pot cool the chips,with a fan in the right direction the chips was around -30°/-40°.

 

But my cpu pot was very long,i think gigio have a short cpu pot and the chips was around -50° or more...the smoke exits at -180°.

 

But may be it is a error,gigio have more than 400 cpu...10 benchs for cpu,is very hard remember the setup for 4000 bench,especially if it does not send immediately the score.

 

For example,i bench 200*10,5 last year,but I don't send yet my score :D

 

200+modules of sdram?You are crazy man:D...and your best module with normal air at what frequency close superpi 1m 2 2 2 7 9?

Russian FederationGraduS says:

He bench on SS....smoke?)

 

I test 200 bad modules :D only 192 22279 air.

Italyruggero says:

He bench on SS....smoke?)

 

I test 200 bad modules :D only 192 22279 air.

 

I do not know, maybe he was on ln2 and he don't remember...but 208 with normal air is impossibile in my opinion,in fact you have not found between 200 modules a module which have the same performance...192 2 2 2 7 9 is very different of 208 2 2 2 7 9.

 

 

When he will read this topic he will reply ;-)

Russian FederationGraduS says:

I ask him, no answer. Very bad man...dont want share info with other overclockers. Thats why i beat all him results on s370.

Italyruggero says:

I ask him, no answer. Very bad man...dont want share info with other overclockers.

 

dear friend,

 

how old are you? ;-)

 

 

Gigio is a "very bad man" only because don't share with info the name or the setup of his ram?

A very bad man is a man who kills children,women.

 

I have spoken with gigio often and in my opinion he is very helpful and i'm not in his team,but he is so helpful i'm so grateful.

 

I see you ask at me,griff,christian ney and gigio the chip of ram,you never use words "please" or "thanks".

 

 

For example,I asked two things at terraraptor and I used at the end of pm "thanks a lot"...

 

 

So,may be gigio don't want share with you his fantastic segret(lol),but...if you are the same gradus of xtremesystems,I can say the same of you:5 years ago I ask you one thing and the reponse is similar at "this is my business",do you remember?I still saved the pm ;-)

 

 

Thats why i beet all him results on s370.

 

In my opinion overclock is only a hobby,I overclock for see the limits of my hardware,not for beet the results of a "obnoxious man"...

 

Life is not only overclock,I think you're tired and stressed for all test of sdram and you say things you do not want to say...

 

...take a break, take a bottle of vodka and a beautiful Russian woman...relax and take it easy. ;-)

 

PS:if the beautiful woman have a sister,i'm single :D

Russian FederationGraduS says:

you very serius man....very....

 

PS and i answer to you on XS. i wrote that i use another board for vcore! need scren of that?

PSS and i very haha on this post) plz dont do another post like this) i very like that mans pushing s370 and we have some competition here. i dont benching 2-3years, and now im here only for s370.

PSSS 1m and cpu-z GOGOGO

Italyruggero says:

you very serius man....very....

 

PS and i answer to you on XS. i wrote that i use another board for vcore! need scren of that?

PSS and i very haha on this post) plz dont do another post like this) i very like that mans pushing s370 and we have some competition here. i dont benching 2-3years, and now im here only for s370.

PSSS 1m and cpu-z GOGOGO

 

Gigio has corrected the setup for help you,but now please stop flame ok?

Russian FederationGraduS says:

I think -60 on this mem fake.

Please log in or register to comment.