Galaxy Designs its Own Dual GeForce GTX 460 Graphics Card

This card looks amazing!

After EVGA's release of its GeForce GTX 460 2WIN dual-GPU graphics card earlier this week, Galaxy wasn't going to sit back. The company rushed in with pictures of its own dual-GeForce GTX 460 graphics card. The card is still in the works, and Galaxy was only able to display its PCB. Galaxy chose a milky-white PCB, which uses two GF104 cores in an internal SLI, powered by a strong VRM circuitry. Each GPU has 336 CUDA cores, and is wired to 1 GB of GDDR5 memory over a 256-bit wide memory interface.

Further, both display outputs of each GPU is wired out in the form of DVI connectors, making the card a single-piece 3D Vision Surround solution. Interestingly, Galaxy chose a bridge chip other than nForce 200 to run the SLI on a stick solution. If Galaxy's implementation clicks, then every AIC partner with its own R&D could work on their own dual-GPU cards, currently, they're held back by non-supply of nForce 200.


United States lesstutrey says:

white pcb is so sexy.

Austria Turrican says:

yeah, it's not so common. :D

TaPaKaH says:

am sick and tired of all those non-ref designs that never make it to retail

Netherlands wesjuhdabomb says:

To bad you can't put 2 tubes on it without soldering some caps and 8pin to the rear of the card.

Belgium Massman says:

Sam OCX said: am sick and tired of all those non-ref designs that never make it to retail

I know you are. It must be so annoying to always plan the white PCB card and never being able to install it in your gaming PC :(

kikicoco1334 says:

i love white pcb but wasn't that an subzero issues? i could be wrong

United States Minor Outlying Islands Kal-EL says:

Whats the bridge chip being used?

Please log in or register to comment.